This week JBL sent me the HPL to audition and compare to the TAD , So i am setting up a high end rig with TAD B`s, `s. the HPL is a bare diaphragm on both sides. Attached Images I really don’t think JBL is spraying the aquaplas for their ego’s. The same. Used JBL HPL Loudspeakers for sale on + second hand hifi sites & shops. Use Hifi Shark to monitor pricing and global availability.
|Published (Last):||28 February 2006|
|PDF File Size:||6.70 Mb|
|ePub File Size:||12.86 Mb|
|Price:||Free* [*Free Regsitration Required]|
JBL D8R2435 2435HPL Beryllium Diaphragm
Together, the voice coil and diaphragm comprise a moving mass of just 0. Mistick Krewe Registered User. Ask a question – opens in a new window or tab.
Cool to see the innerds there Zilchster, thanks. I recall the Be I examined did not have ferrofluid. Send a private message to clubman5. I bet it would be a dramatic improvement over the stock cone mid with lens setup. Find all posts by der geile ami. See all condition definitions – opens in a new window ibl tab Originally Posted by der geile ami What do you not like about the sound?
Select a valid country. Back to 2435hpll page. Find all posts by allen.
The result is an increase in dynamic headroom and precise definition. I’ll figure something out, no doubt. Originally Posted by duron tarik i can hear all the comb filtering. Postage cost can’t be calculated.
Read more about the condition. See full item description. Extra Tabs by vBulletin Hispano. However, in frequency response tests at least, any performance differences were indiscernable: I will do this over the weekend my shop and post my thoughts of this comparison. Originally Posted by Earl K.
With more of the frequency spectrum coming from a single point, the quality of sound jvl more focused and less smeared. In the same vein, and the rest of them x has Silpad on the face for thermal conductivity to metal horns. The ND is an un-believably clean and accurate driver that is capable of high output to a very low frequency with no distortion or clapping of the diaphragm. Mobile JBL almost ready Seller assumes all responsibility for this listing.
Allen Last edited by allen: Originally Posted by allen Sounds like a fun comparison.
What are you doing! That’s not an aluminum block it bolts to on that, is it? Please enter a valid postcode. However, in frequency response tests at least, any performance differences were indiscernable:. Send a private message to pbellsound.
Find all posts by 2435npl If the Be does not have ferrofluid, the larger back cap with fins would make sense for heat dissipation.
This JBL driver is used in the Vertec system. BMS drivers require much less energy than conventional diaphragms, allowing a much higher SPL, less dynamic compression, an increase in transient response, and lower harmonic distortion than traditional designs.
Used JBL HPL Loudspeakers for Sale |
Listen to the drivers only. Last edited by allen: What do you guys think? Skip to main content. I was asked off-forum my opinion on this topic thread and I think I have some useful and real world experience to add to the thread. Now you have to take it to JBL so 2435hll can put the gas back in in their special clean room!
JBL 2435HPL Driver 125-30001-00X
I assume you bought the Bes on the used market? Questions and answers about this item. The time now is